QRTB 2.0.7 for Nova 436Q base stations has been released. This version adds DC mode and SAS support. Starting with this version, we will also be changing the CloudCore PLMN to 314030.
Remember, a license key will be required to unlock CA or DC mode. This key should have been provided at time of purchase, so if you have not received a license key, please reach out to sales (sales_na@baicells.com) to obtain the key.
SUPPORTED HARDWARE:
Nova 436Q (4*1W eNB | mBS31001)
NOTICE: BEFORE UPGRADING THE ENB, you will want to check if any Baicells Cat6 (Atom OD06) CPEs are connected to the eNB. For every CAT6 CPE which is connected to the eNB, you will want to verify that roaming is set to enabled. If roaming is set to disabled on any CAT6 CPE, it will prevent them from attaching to the eNB after the upgrade if the SIM card used does not begin with “314030”. These CPEs also use the following model names: EG7010CM11, EG7010AM11, or EG2013BM11. You can find the model names listed in the OMC under CPE > Monitor. From the CPE webgui, you can find the roaming setting on the Settings > LTE > Internet Settings page.
Software Download: https://na.baicells.com/download/BaiBS_QRTB_2.0.7.IMG
Changelog:
==========================
Version BaiBS_QRTB_2.0.7
--------------------------
New Features:
- Added: Dual Carrier (32+32 users)
- Added: SAS Support
Bug Fixes:
- Fixed: Dummy TTI issue may cause memory leak and reboot eNB if in DC mode
- Fixed: Changing IPsec Enable/Disable parameter may cause coredump
- Fixed: Enabling SAS with MME pool enabled may cause coredump
- Fixed: LGW may not assign an IP addresss to a UE in bridge mode configuration
- Fixed: 2nd Cell may not become active after system startup
- Fixed: Cell not active after changing carrier setting in OMC
- Fixed: Coredump when when modifying P-max parameter in webGUI
- Fixed: OMC will incorrectly display same UE count for both cells in DC mode
- Fixed: Coredump caused by error message reported by DSP to MAC
- Fixed: Coredump caused by TR069 message format issue
Known Issues:
- UE count may display wrong in high noise environment due to false detection of UL QCI
Requirements:
- Software license required to unlock CA or DC mode